Experimenting With Vegetation

In February I acquired some artificial grass from IKEA for an experiment with high vegetation looking a bit like the rushes growing in poorly drained areas. Although intially very promising, I ditched the solution after having installed a few tufts of cut down IKEA grass. It was too obviously plastic grass from IKEA and no amount of matt varnish or detail painting could hide that - particularly as they were placed at the layout's front edge. Now a new experiment is unfolding at the same location: planting butterbur.

At the right end of the small layout new, experimental plants have started growing

I don't know where I bought the plastic plants with large leaves, but they were probably cheap. I found 3 wraps of them in a bag while cleaning out a cupboard and they look like a type of plastic plants used by by people keeping fish in aquariums. They are from the time when I modelled in 1/35 scale and I probably decided they were too large for 1/35. Now I wanted to try them out in 1/19 scale.

A handful of plants were wiped with a wet cloth and when dry given a spray with black primer. The root end were cut off and the leaves painted green. Once dry they were stuck into holes on the small slope at the layout's right end.

3 stages of butterbur for Nystrup Gravel (from top down): unpainted plant, primed and painted. The fourth plant is as bought with stem and roots still attached.

First impression of the plastic plants isn't too bad. With some groundcover and a little colour variety these plants stand a greater chance of survival in the Nystrup biosphere than the IKEA grass.

My greatest concern is if the paint will hold on to the soft plastic over time. I have tried to rub the primer off the leaves without succes so perhaps I'm worrying too much. No one will be touching the plants regularly and they can be spot painted if needed.

The roots and stems have been put into storage. They may come in useful later.