Plank Road at Lorry Ramp

With the recent adding of grass near the loading ramp the only 'naked' areas remaining on the segment was the road area below the ramp as well as a short piece of track lacking ballast. The plank road under the ramp's chute needed lengthening and the rest of the road area covering with a suitable mix of sieved gravel. That work has now been finished (as if a model railway is ever finished!).

Current status at the lorry loading ramp at Nystrup Gravel. Ground work is finished as far as plank road and gravel surface concerns. I still haven't got a lorry to display and the Ferguson acts as replacement vehicle.

With a mix of differently sized grey stained planks produced, they were glued to the layout's surface. Some withered grass tufts were placed up against the plank retaining wall under the chute. A few green tufts were placed at the end of the loading area to illustrate a more humid ground. A few black spots were painted on the layout surface. They are the beginning of some small waterfilled potholes I plan to install. If they don't come out as expected they can easily be filled in.

The stained planks have been glued in place under the loading ramp's chute. The planks helped avoid lorries getting stuck in rainy weather and wet conditions. The plank road is known from several Danish industrial railway locations and Nystrup Gravel naturally used the method too.

A first layer of gravel and sand in differing tones was spread over the loading area with a plastic spoon. I decided to keep the gravel quite level without the ruts many modellers would have created in a similar area. I have gone with a quite subtle level of uneveness. More can always be added if I decide to. A few dead leaves were scattered where they would assemble due to wind and traffic. As usual the gravel was glued with diluted white glue.

The first layer of gravel and sand in differing tones is being glued down. I use a syringe loaded with a mix of PVA glue, water and washing up liquid. It's Friday afternoon and I enjoy a glass of homemade grape juice with vodka and sparkling water - always add a level area the size of a glass on each layout segment!

The next task at the loading area will be working with the colours of the gravel layer and work on the puddles.

Despite the amounts of gravel loaded into lorries the loading ramp at Nystrup Gravel was a cramped location. Lorries had to reverse under the chute with not much room for manoeuvering.